NHTSA Campaign Number: 18E060
Manufacturer SynTec Seating Solutions, LLC
Components SEATS
Potential Number of Units Affected 235
Seat Mounting Foot May Detach from Floor/FMVSS 210
If the seat mounting foot detaches from the floor, it can increase the risk of injury in the event of a crash.
Summary
SynTec Seating Solutions, LLC (SynTec) is recalling certain S3B 45″ Restraint School Bus Seats. The seat’s foot may pull through the bolted joint at the bus floor. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 210, “Seat Belt Assembly Anchorages.”
Remedy
SynTec has notified the bus manufacturer that purchased the seats, and dealers for those manufacturers will install a washer between the rear mounting foot and the bus floor, free of charge. The recall began on August 7, 2018. Owners may contact SynTec customer service at 1-336-862-7509. SynTec’s number for this recall is RES101.
Notes
Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.
IMPORTANT SAFETY RECALL
SynTec Seating Solutions, LLC
July 31, 2018
RES101
NHTSA # 18E060
Notice to Owners
See Enclosed VIN List
Subject: S3B School Bus Seat: 45” Restraint Seats
This notice is sent to you in accordance with the requirements of the National Traffic and Motor Vehicle Safety Act. SynTec Seating Solutions, LLC has decided that a noncompliance with Federal Motor Vehicle Safety Standard FMVSS 210: Seat Belt Assembly Anchorages in certain Thomas Built Buses equipped with S3B 45” Restraint school bus seats. Failure of the floor mount foot was determined to be the root cause of the noncompliance. This noncompliance could result in the floor mount foot pulling through the bolted joint in the event of a severe collision. A washer will be installed between the rear mounting foot and bus floor bolt heads to increase surface contact of the bolted joint, preventing pull through.
To arrange for repairs you should contact your local Thomas Bus dealer immediately or SynTec Seating Solutions, LLC. SynTec will remedy the noncompliance without charge. The repair should take approximately 30 minutes depending on your vehicle and will be performed at no charge to you. Parts are currently available for the repair.
If you do not own the vehicle(s) that corresponds to the identification number(s) which appears on the Recall Notification, please return the notification to SynTec Seating, LLC 200 Swathmore Ave High Point, NC 27263, Att. Warranty Department with any information you can furnish that will assist us in locating the present owner. If you have leased this vehicle, Federal law requires that you forward this notice to the lessee within 10 days.
If you have paid to have this recall condition corrected prior to this notice, you may be eligible to receive reimbursement. For further information, please contact SynTec at (336) 862-7509.
If you have any questions about this recall, please contact the Warranty Department at (336) 862-7504, 8 a.m. to 5 p.m. Eastern Time, Monday through Friday. If you are not able to have the noncompliance remedied without charge and within a reasonable time, you may wish to submit a complaint to the Administrator, National Highway Traffic Safety Administration, 1200 New Jersey Avenue, SE., Washington, DC 20590; or call the Vehicle Safety Hotline at 888 327-4236 (TTY: 800-424-9153) or to https://www.safercar.gov. In Canada you may contact Transport Canada-Road Safety, rue Noel, Gatineau, Quebec J8Z 0A1 or call 1-800-333-0510.
We regret any inconvenience this action may cause but feel certain you understand our interest in motor vehicle safety.
SYNTEC SEATING SOLUTIONS WARRANTY DEPARTMENT
Enclosure
IMPORTANT SAFETY RECALL
SynTec Seating Solutions, LLC
July 31, 2018
RES101
NHTSA # 18E060
Dealer Notification
Subject: S3B School Bus Seat: 45” Restraint Seats
S3B 45” Restraint Seats manufactured February 5, 2018 through June 10, 2018
General Information
SynTec Seating Solutions, LLC has decided that a non-compliance with Federal Motor Vehicle Safety
Standard FMVSS 210: Seat Belt Assembly Anchorages exists in certain school buses equipped with S3B 45” restraint school bus seats. The non-compliance was initially identified based on routine testing conducted at SynTec’s manufacturing facility in High Point, North Carolina. The S3B 45” restraint seat failed to meet the testing requirements, allowing the floor mount foot to pull through the bolted joint above 4500 lbs. (5000 lbs. minimum requirement). The installation of a washer between the rear mounting foot and bus floor bolt heads increases surface contact of the bolted joint, preventing pull through.
There are approximately 37 vehicles and 235 seats involved in this campaign. The population is limited to 1 Dealer in 1 State with fewer than 10 total customers.
Additional Repairs
Dealers must complete all outstanding Recall campaigns prior to the sale or delivery of a vehicle. A Dealer will be liable for any progressive damage that results from failure to complete campaigns before sale or delivery of a vehicle.
Owners may be liable for any progressive damage that results from failure to complete campaigns within a reasonable time after receiving notification.
Work Instructions
Please refer to the work instructions.
Replacement Parts
Replacement parts are now available and can be obtained by ordering from SynTec Seating Solutions, LLC., 200 Swathmore Ave, High Point, NC 27263.
Our records show your dealership has ordered vehicles involved in campaign number RES101 (NHTSA # 18E060). A list of the customers and vehicle identification numbers is attached. Please refer to this list when ordering parts for this recall.
Table 1 – Replacement Parts for RES101
| SynTec Campaign # | Part# | Description of Parts in Kit |
| RES101 | 2496686 | 3/8” Flat Washer (Qty 2) |
| 2512077 | 7/16-14 Flange Nut | |
| RES101-WI | Work Instruction (1 per kit) |
Table 2 – Labor Allowance
| Campaign# | NHTSA# | Time Allowance (Hours) | Procedure |
| RES101 | 18E060 | .2 hours per seat | Install (2) 3/8” Washer |
Claims for Credit
The dealer or customer will be reimbursed for labor to install reinforcement part per Table 2. Parts will be provided at no charge. To receive reimbursement for labor submit your claim / invoice to: SynTec Seating Solutions, LLC. 200 Swathmore Ave, High Point, NC 27263 ATT. Warranty Department
Claims/Invoices may also be emailed to [email protected]. All claims are to be submitted within 30 days of completing this campaign.
Claim / Invoice Information
Please include the following information on your claim or invoice.
Recall # RES101 / NHTSA 18E060
Vehicle Identification Number (VIN)
Number of kits # RES101 (per Table #2)
Number of Seats repaired
Labor Rate
Labor Hours per Table #2
Please retain a copy of your claim / invoice for your records.
Remedy Instructions and TSB
7-24-18
Owner Notification Letter
July 31, 2018
RES101
NHTSA # 18E060
Manufacturer Notice
July 31, 2018
RES101
NHTSA # 18E060
Recall Acknowledgement
August 16, 2018
- COMPLETE LEATHER CARE KIT (SPI_109_16) - This Chemical Guys kit includes Cleaner and Conditioner, two 16 oz bottles that work together to clean, restore, and protect leather in cars, homes, and more
- CLEANS AND CONDITIONS - Chemical Guys interior cleaner for leather that lifts dirt and grime while the Conditioner nourishes and restores leather suppleness, leaving interior surfaces soft, smooth, refreshed
- VERSATILE USE - This car leather cleaner and conditioner kit is designed for automotive interiors and equally effective on leather furniture, apparel, shoes, boots, jackets, handbags, and other everyday leather goods
- SAFE & EFFECTIVE CAR LEATHER CONDITIONER AND CLEANER- pH-balanced formulas are safe for all natural, synthetic, and sealed leathers; gentle cleaning power helps prevent cracks, fading, and drying while preserving the original finish
- EASY TWO-STEP SYSTEM - Use this Leather Cleaner for car interiors to remove embedded dirt, then apply Leather Conditioner to hydrate and protect; achieve professional results at home or in your garage
- NON TOXIC, GENTLE CLEANER: Our proven, rejuvenating formula is a powerful, fragrance-free cleaner ideal for all your leather goods (except suede). EPA Safer Choice certified
- CLEAN ALL TYPES OF LEATHER: Quickly and gently removes dirt, oil, tough stains and grime from car seats
, truck seats, upholstery, furniture, handbags, purses, shoes, accessories, saddles, and tack. Effectively cleans leather of all colors, including white leather. Safe for exotic leather, faux, vinyl - SAFE FOR YOU, SAFE FOR LEATHER: Made with non-toxic, high-quality ingredients that makes your leather last longer. Safe for people, pets & your leather
- TEST & APPLY: Apply leather cleaner with a lint-free cloth. No need to scrub or rub — simply wipe down and allow it to dry. Spot test on each leather item first. Not for use on suede
- AMERICAN MADE SINCE 1968: Our premium leather care formulas have had a cult following among leather experts, retailers and high-end car and furniture makers and enthusiasts for over 50 years.
, truck seats, upholstery, furniture, handbags, purses, shoes, accessories, saddles, and tack. Effectively cleans leather of all colors, including white leather. Safe for exotic leather, faux, vinyl
- BRING YOUR LEATHER BACK TO LIFE: Safely remove dirt, soil & residue to soften, strengthen & moisturize neglected leather.
- EASY TO USE FORMULA: Our multi-action formula conditions & protects in one simple step to maintain and restore any finished leather surface
- MULTIPLE USES: Use regularly on accessories such as leather, purses, shoes, boots, briefcases & handbags. Condition leather sofas, couches, and chairs to restore their beauty and suppleness.
- UVX PROTECTION: Weiman Leather Conditioner contains UVX-15 sunscreen which protects all types of leather from sun damage, fading, drying & cracking
- CARE FOR YOUR AUTO INTERIOR: Perfect for cleaning, protecting, and restoring your car, SUV, truck, motorcycle or Jeep seats and interior.
- TARGETED PERFORATION CARE (SPI92016): This leather-focused formula reaches deep into ventilated leather zones to support effective cleaning while working with any leather conditioner or protectant to maintain seating clarity and interior balance.
- FLOW-THROUGH CLEANING ACTION: Designed for perforated leather surfaces, this cleaning solution moves through micro-channels in leather inserts and pairs seamlessly with conditioner and protectant systems to help sustain comfort, texture, and long-term feel.
- DEEP LEATHER CLEANING SUPPORT: Removes trapped buildup across leather perforations for refreshed structure while preparing leather panels for conditioner and protectant application, helping preserve natural touch and consistent interior refinement.
- DETAILING-LEVEL LEATHER RESULTS: Enhances full-surface cleaning across leather inserts and bolsters, delivering precision coverage that works alongside any conditioner and protectant to maintain depth, softness, and uniform cabin appearance.
- ROUTINE LEATHER MAINTENANCE: Ideal for scheduled interior cleaning on leather seating materials; supports follow-up use of conditioner and protectant products, helping leather stay smooth, breathable, and evenly balanced through repeated care.
- POWERFUL LEATHER CONDITIONER: Leather Honey penetrates deep to protect new leather and rejuvenate dry leather and old leather. This non-toxic leather conditioner has no silicone, solvents or animal products
- NON-TOXIC, GENTLE CLEANER: Our proven, rejuvenating formula is a powerful, fragrance-free cleaner ideal for all your leather goods. EAP Safer Choice certified.
- RESTORE ALL TYPES OF LEATHER: Clean & Condition leather furniture, car seats, shoes & belts. Great for all colors of leather, including white. Use on leather upholstery, boots, purses, saddles & tack. Not for use on suede
- SAFE FOR YOU, SAFE FOR LEATHER: Made with non-toxic, high-quality ingredients that make your leather last longer. Free of PFAS forever chemicals and safe for people, pets & your leather
- AMERICAN MADE SINCE 1968: Our premium leather care formulas have had a cult following among leather experts, retailers and high-end car and furniture makers and enthusiasts for over 50 years.
Last update on 2026-06-26 / Affiliate links / Images from Amazon Product Advertising API
This product presentation was made with AAWP plugin.