SMB-152 – Disc Brake Pad Installation – New Flyer

SEOCONTENT-START
SMB-152 1 of 2
SERVICE MANUAL BULLETIN
This Service Manual Bulletin is prepared by the Publications Department of New Flyer Industries
Canada ULC. Refer to details below.
The New Flyer vehicles described in this manual may be protected by one or more
patents and design applications or registrations in the United States and Canada,
and in other countries. Refer to “Vehicle Patent Information” in this manual.
Copyright © 2015 New Flyer Industries Canada ULC
ISSUE DATE: Dec 10 2015
SMB-152
APPLICABILITY
VEHICLE LENGTH  30ft.  35ft.  40ft.  60ft.  ALL
VEHICLE TYPE  High Floor  Low Floor  Invero®  Xcelsior®  ALL
FUEL TYPE
 Diesel  Electric  CNG  LNG
 ALL
 Diesel/Electric  Gas/Electric  Fuel Cell
SUBJECT Disc Brake Pad Installation
SECTION TITLE 1 – FRONT AXLE & SUSPENSION – VOK-07F
2 – REAR AXLE & SUSPENSION – HY-1336-P HY-1350-F
DETAILS This bulletin provides revised OEM information on the installation of the
disc brake pads on your New Flyer Vehicle.
This bulletin supersedes all prior information on this subject already provided
in your New Flyer Service Manuals and SMB-149 released October
20, 2015. Make this Service Bulletin available to service personnel to
inform them of changed information.
2 of 2 SMB-152
SERVICE MANUAL BULLETIN
SMB-152
The New Flyer vehicles described in this manual may be protected by one or more
patents and design applications or registrations in the United States and Canada,
and in other countries. Refer to “Vehicle Patent Information” in this manual.
Copyright © 2015 New Flyer Industries Canada ULC
1. Front & Rear Disc Brakes
1.1. Installation
☞NOTE:
It may be necessary for the abutments of
the carrier and guiding surfaces of the
brake pad to be coated with a suitable permanent
lubricant. See “Fig. 1: Areas to
Apply Lubricant” on page 2. The following
products are approved for this application:
Textar CERA TEC®, ATE Plastilube®, Dow
Corning P-40® Paste.
DO NOT use copper based lubricant.
DO NOT get any lubricant on the pad
and/or disc face or guide sleeve parts.
Fig. 1: Areas to Apply Lubricant
s122280a.svg